Thread: off it goes
View Single Post
Old 02-27-2020, 12:09 PM   #1316
CHROMAHOLIC
Registered User
 
CHROMAHOLIC's Avatar
 
Join Date: May 2009
Location: Ontario, Canada
Posts: 771
Re: off it goes

Quote:
Originally Posted by rodstored-72 View Post
thank you for your answer, it appears that the laser cut piece is attached at the factory holes? also would you share how the wire mesh is attached to the laser cut piece?

thank you again
Yes laser cut piece is an exact copy of the factory plastic one, so yes mounting holes all lined up. As for the mesh, we used a panel bond adhesive to keep them in place. We used the panel bond because at that time I was leaving the finish mirrored so we couldn’t tack weld it, but now that we painted it we could of done a small tack to keep them in place.
CHROMAHOLIC is offline   Reply With Quote