[Gregski]

ok so after mocking with just the Idle Mixture screws and then just with the Idle Speed screw, it was now time to mess with both

so for this part we leave the Idle Speed screw at 2 turns turned in (so 1/2 a turn beyond the sweet spot of exposing just a .020" transfer slot)

-TIMING- - - - - - - - - - - - - - - - - - - - - - - - - - - IDLE - - - - - - - - -IDLE - - - - - - AFR - - - - - - AFR
ADVANCE - - - - - RPM - - - - - VACUUM - - - - - MIXTURE - - - - - - SPEED - - - - - LEFT - - - - - RIGHT - - - - - - - - - COMMENTS

- 10° - - - - - - - -550/750 - - - - -15/16" - - - - - - 1.25 turns- - - - - -2.00 turns - - - - 15.x/16.x - - - 15.x/16.x - - - - when we leaned out the mixture by turning the screws 1/4 turn to only 1 1/4 out the RPMs wigged out and we were way too lean

- 10° - - - - - - - - -700 - - - - - - 15/16" - - - - - - 0.50 turns - - - - - -2.00 turns - - - - - 14.x - - - - - 14.x - - - - - this yielded a 14.x AFR but its at the 1/2 turn minimum (the minimum being 1/2 a turn the maximum being 4 turns guideline)