Quote:
Originally Posted by 68 short step
where would i get a set of 1.5 blocks w/ loner U bolts? the truck was set-up for a 7" (bag) ride height....
you talkin bout the A/C compressor or the air system compressors?
|
CPP for the blocks w/ bolts. I think the kit is $60-70.
You have a little leeway in how tall the bag can be, but not much. Most (2600lb)bags are designed to be installed at ride height at 6" tall. You can waiver either way by a 1/2" or so, but outside of that they will not ride as well. You can use the blocks to keep the bags at 6" installed, but ride 2" lower than you would without them. Think of the bag as a non-adjustable coil spring when at ride height. The pressure will vary based on load, but the overall height should be 6". Clear as mud?
I was asking about the A/C compressor. It seems to fit very well. Is it smaller than the usual truck compressor?
__________________
-Chris
Instagram
_elgringoloco_
'70 Short-Wide How to: Ruin a perfectly good C10
‘70 Blazer ConversionHow To: Ruin a Perfectly Good 4wd
'72 Highlander How To: Ruin a Perfectly Good K/5 (SOLD)
'72 Blazer 2WD How to: Ruin a perfectly good Blazer (SOLD)
'05 Yukon Daily Driven (not so stock) Yukon (SOLD)
‘07 Yukon Denali (daily)
Members met list: SCOTI, darkhorse970, 67cheby, 67cheby'sGirl, klmore, porterbuilt, n2billet, Fastrucken, classicchev, Col Clank, GSFMECH, HuggerCST, Spray-Bomb, BACKYARD88, 5150, fine69, fatbass, smbrouss70, 65StreetCruiser, GAc10boy