Quote:
Originally Posted by JML55
Thanks, the rear end is out of a S10 Blazer 4X4 and comes with disc brakes and 3:73 gears. Its not very strong rear end but for a cruiser its fine. Its a little bit narrow so i ended up relocating the calipers to a lower position on the backing plate so the would not touch the inner edge of the box. The 4link kit, i just went with what i could afford at the time,
|
Right I think I read that somewhere in your thread, my bad! I have a GM 10 bolt 8.5" so I'm keeping it, I'm going with an aftermarket brake set up from KMS Tools I think, closest and cheapest, states can be a bit of a delay these days and shipping expensive. As for the 4 link, I think I'm going to get the Welder Series. Thanks for your reply, I can only hope mine will be as half as good as your Jimmy!