[MP&C]

This is a mod I had discussed with the owner quite a while back, and she asked about it again a couple weeks ago, so I guess we're on the hook to shave some seams..





The bolting plates are cut out of the way, and the folded flange is trimmed, leaving a bit of extra to allow for fine tuning the weld joint.











Bottom of the fender is cut loose from the bolting plate using the cutoff wheel. Then sanding the face of the fender leaves a contrast at the bend of the flange for a good guide for trimming with snips....











Planishing out the fold to fill the gap....








Using clamps to test fit. Still needs some fine tuning for zero gaps, but we'll finish that another day..