Quote:
Originally Posted by joedoh
you would only use the indicator wires for each side and then wire the column as a single bulb setup, you only use the brake wire if you have the column wired that way and again, only if you have separate bulbs.
the reverse lights run through a reverse switch on the trans.
if you replaced the lights, you would still have the same wiring decision to make, it would be a lateral move. regarding the colors, for whatever reason, aftermarket lights seem to follow a different, non intuitive wire color scheme
|
The wiring through the column is pretty much as shown in this diagram.
So I assume i then run the following wires to the two positive (black) you mentioned.
- left rear turn
- left tail park
Ground the 1 wire on drivers side.
Then repeat for Right (passenger side).
If thats right ....... my question would be ..... the reverse light wires of the transmission - do they "plug/splice" into these wires also ..... or do I buuy seperate backup lights and mount them and wire to those.
thx