[Osker]

I soon learned that the PO’s inside rocker patch job was about a half inch short of where it needed to be, meaning the outside edge was a half inch too short from where it needed to be.

I had an idea that it was off when I was test fitting the rocker a while back, the PO had one attached with sheet metal screws for mock up but the gap was off in the channel between the rocker and the floor edge.

I checked and rechecked this dozens of times by measuring my C10 from the seat mounting holes and some other reference points.

I chopped of his work and started on my own journey. The replacement panel was originally intended for the C10 but it volunteered for practice.