The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project 1966 Chevy Stepside with family history

NCD1966 · 03-29-2011, 11:30 PM

well here is the motor progress as of today.
just got these valve covers in. I have a friend with a power coating shop, and I will send him my intake and valve covers to get a clear power-coating on them. I will never have to polish the valve covers and clean the intake again.

Still havent figure out if these 1968 camaro 1-3/4 headers will work. But I compared them to my 1-5/8 truck headers and the tubes match the same. Only thing I think I'll have to modify is the collectors. Might need to heat them up with a rose bud and bend them down a bit.

03-29-2011, 11:30 PM	#31
NCD1966 Registered User Join Date: Jun 2010 Location: Lafayette , La Posts: 404	Re: Project 1966 Chevy Stepside with family history well here is the motor progress as of today. just got these valve covers in. I have a friend with a power coating shop, and I will send him my intake and valve covers to get a clear power-coating on them. I will never have to polish the valve covers and clean the intake again. Still havent figure out if these 1968 camaro 1-3/4 headers will work. But I compared them to my 1-5/8 truck headers and the tubes match the same. Only thing I think I'll have to modify is the collectors. Might need to heat them up with a rose bud and bend them down a bit. __________________ 1966 Chevy C10 Stepside 355ci sbc with 3speed OD 2021 GMC Sierra 1500 AT4 6.2 1980 Chevy Camaro z28 383ci 1990 Chevy Suburban 350 tbi 2x4 (sold) 1984 Chevy C10 sliverado short fleet 1997 Chevy C1500 short fleet Last edited by NCD1966; 03-29-2011 at 11:32 PM.