[krue]

Door vent window

1. Lower the window all the way
2. remove the door trim panel
3. remove the door lock knob
4. remove the screws which attach the vent window lower
assembly to the door panel
5. loosen the inner and outer panel screws which are accessable
through the hole to the rear of the lower vent pivot
6. slide the main glass to the rear, away from the vent window
7. turn the complete assembly 90 degrees and guide it up and
out of the door
8. installation is the reverse of the removal

Door window glass and regulator

1. lower the glass completely, remove the window regulator
handle and the door lock knob
2. remove the door armrest and trim panel
3. remove the door vent window (above)
4. slide the main window glass forward until the front roller
is in alignment with the notch in the sash channel. Disengage
the roller
5. push the window forward and tilt the front edge up until the
rear roller is disengaged
6. return the window glass to the level positionand withdraw it
from the door
7. if necessary, remove the mounting screws and withdraw the
regulator assemblythrough the lower opening in the door
8. prior to installation lube the regulator mechanism with chassis
grease
9. installation is the reverse of removal

Hope this helps.