Re: 72 SWB STEP "Army truck" Budget Build
I did a few odds addends today. I got the flex fan swapped out for a factory clutch fan. I got the front light harness installed. I removed the power brake booster in order to install the rubber boot on the shaft that the body shop left off. I also had to drop the steering column in order to install the brake pushrod to the pedal. I also got the new tail light side marker and backup lenses installed. I am trying to decide what to do about a rear light harness. Mine is butchered up like most but a repro is $100 (!)
I have already had to buy new master cylinder to frame brake lines as the bodyshop lost those too. I have run into an issue with the line that goes into the rear of the prop valve. The hole in the valve is around 3/4 to 1"...I have another prop valve but it's a little different and it just has a 3/8" threaded hole that the brake line will thread in to. I wonder if the took the line out of the valve and lost more than the line. (?)
Posted via Mobile Device
|