The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Morphing a 1956 Chevy 3200 onto a 2001 Tahoe Chassis

AllenF · 09-07-2021, 08:36 PM

I will dig around to see if I have any photos but I can tell you that I started with 1 x 4 steel box tubing and cut holes in it for the radiator base. Then, welded uprights to a top plate of 1x1 steel tubing, so it was pretty much raw fabrication. The mounting to the frame rails used the original rubber mounts (2 more holes in lower plate) but that was about it.

09-07-2021, 08:36 PM	#104
AllenF Registered User Join Date: Nov 2018 Location: West Linn Posts: 47	Re: Morphing a 1956 Chevy 3200 onto a 2001 Tahoe Chassis I will dig around to see if I have any photos but I can tell you that I started with 1 x 4 steel box tubing and cut holes in it for the radiator base. Then, welded uprights to a top plate of 1x1 steel tubing, so it was pretty much raw fabrication. The mounting to the frame rails used the original rubber mounts (2 more holes in lower plate) but that was about it.