The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

TA_C10 · 06-23-2019, 11:38 PM

Update - Vintage Air Vents

Cut the holes for vents today. Vintage air templates worked just fine. I read a tip not to use a hole saw so I used my small body saw instead. Worked fine. I think I could have used a hole saw without issue but this worked too.

Center vent I don't like. it sticks out from the dash. I knocked/bent the top metal out best I could without distorting it but still not enough. I guess I will have to add some body filler at the top to make it fit right. Not sure what happened here but it sucks.

Passenger side:

Driver Side:

06-23-2019, 11:38 PM	#218
TA_C10 Registered User Join Date: Jun 2018 Location: Texas Posts: 1,353	Re: TA_C10: Stage 1 Update - Vintage Air Vents Cut the holes for vents today. Vintage air templates worked just fine. I read a tip not to use a hole saw so I used my small body saw instead. Worked fine. I think I could have used a hole saw without issue but this worked too. Center vent I don't like. it sticks out from the dash. I knocked/bent the top metal out best I could without distorting it but still not enough. I guess I will have to add some body filler at the top to make it fit right. Not sure what happened here but it sucks. Passenger side: Driver Side: __________________ TA_C10 Stage 1 build - http://67-72chevytrucks.com/vboard/s....php?p=8333444 "It's only money". Last edited by TA_C10; 06-23-2019 at 11:53 PM.