Re: Nutserts
I will start things off by saying that I'm on the lookout for a nutsert tool... I am installing mirrors on a couple of trucks where either the factory nutserts have deteriorated or the PO just drilled and screwed the mirrors into the door skin -- Splendid.
I hunted down the correct vinyl coated nutserts that the factory uses and I don't even remember where I found the information. I finally cornered them at I think Fastenal and had to buy a box. So if you need a couple...
I would like to get a decent installation tool without spending a whole C-note for just needing it a few times. I'm open to suggestions and would ask if anybody has had good luck with the HF version. I will copy a post over from SCOTI about a tool he found and we can get rolling from there if anybody else has interest in this.
Last edited by LT7A; 08-26-2020 at 05:38 PM.
|