Re: 1967 Custom Sport Shop Truck
This floor went SOOOOOOOOOOO much faster.
I didn't waste any time doing extra tape lines, writing "cut", etc... if I put a line down, measure it 3x... that's good enough. I did add an extra mark that would be at the 12" line after it was cut. I think I took the pic at an angle, because it was dead on 12" after it was cut.
I did add tape to my "Match Line" in case it got rubbed off. Metal ruler in the background to show this baby is FLAT!
Front missing 12" and fully tacked all the way down.
Last edited by 67ChevyRedneck; 04-23-2017 at 04:26 PM.
|