The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**1971Stepside** · 10-24-2018, 03:08 PM

I continue to mess around with these power steering hoses to try to get them in the right spot and look decent. I'm a little worried they may interfere with the shift linkage, but will have to wait and see. Ended up having to use some small amount of black rubber hose to make it all work. I didn't want to change the low pressure fittings on the pump in case I ever needed to replace it. If the pictures post sideways I'm sorry...had it figured out until I got a new computer.

10-24-2018, 03:08 PM	#47
1971Stepside Almost Satisfied Join Date: Mar 2002 Location: Springfield, MO Posts: 2,928	Re: 1971 Stepside LS Build I continue to mess around with these power steering hoses to try to get them in the right spot and look decent. I'm a little worried they may interfere with the shift linkage, but will have to wait and see. Ended up having to use some small amount of black rubber hose to make it all work. I didn't want to change the low pressure fittings on the pump in case I ever needed to replace it. If the pictures post sideways I'm sorry...had it figured out until I got a new computer. Attached Images __________________ 1971 C10 Stepside. LSx 6.0 with BTR Stage IV, Speed Engineering Headers, 4L80e transmission w/3200 Circle-D Stall. 3.73. Posi. Purchased this truck when I was 17. I started the rebuild (or take apart) in 1993. I have drug it around all over the country in pieces. Finally back on the road in 2021. "I can't complain, but sometimes I still do. Life's been good to me so far."