The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**aotte1** · 10-11-2015, 03:02 PM

Have the bed off and panels taken apart. Their are a couple of welds on the rear that need to be ground apart. Will be doing some bumping to dings and few small dents, along with some welding up of extra holes and a few cracks.

You can see the small weld area that needs to be removed in the first photo. It is where the lower part of the rear panel connects to the side panel. I used the die grinder to cut the weld.

Les

10-11-2015, 03:02 PM	#92
aotte1 Senior Member Join Date: Oct 2013 Location: lousiville Ky Posts: 2,637	Re: 64' K10 Project Long Bed Have the bed off and panels taken apart. Their are a couple of welds on the rear that need to be ground apart. Will be doing some bumping to dings and few small dents, along with some welding up of extra holes and a few cracks. You can see the small weld area that needs to be removed in the first photo. It is where the lower part of the rear panel connects to the side panel. I used the die grinder to cut the weld. Les Attached Images Last edited by aotte1; 10-11-2015 at 03:20 PM.