Re: New project
I tore into it today . I checked the fuel pressure and it was dead on 6.5 psi . Drained the tank , cleaned the filter ( wasn't bad ) . Then pulled the rear bowl . Float level was to high . I miss read the instructions . It said fuel to the bowl inspection plug threads and 2 turns . This meant 2 flats or ad 1/3 turn. Once I left ( the starting line ) the fuel pump would force it to spill over making it just rich enough to kill some numbers . Then when the motor would use enough to lower the level it would run out the back clean. Should be good to go . Going out Friday to test and make 1/4 mile passes to see if I can get enough cylinder heat to reseal the rings.
Last edited by hotrod 80; 05-09-2018 at 08:06 PM.
|