Re: '63 GMC 4x4 "Just Because I can" Build
So in my last post on your thread, I asked if you pressed the extensions into the housing... well, what I should have asked was if you had to extend the long side of the eaton housing any more than the section that is inside the inner C. Or did you have to cut the long side down any? In the pictures it doesn't look like the long side had to be extended out more. All I can see is your plug weld grinds. Also, what was the wall thickness of the eaton housing? did you have to turn it any to get it true so it would fit over your freakin awesome axle extensions?
Too many questions?
|