The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Northern 52 · 03-15-2019, 08:34 PM

I'm slowly plugging away on my 52 on an S10 frame. I am plumbing my transmission and decided to pick up an 8 x 14 cooler for it. It looks like it would fit nicely below the rad on the risers for the rad. I did the cross-member under the frame and sloped risers for the rad. Not knowing what the finished clearance would be but I am wondering if there will be enough air flow with the cooler in that location. From the pictures, the lower baffle below the rad to the grill looks like it might be at the half way point on the risers. My baffle is snowed into my shed and the way our weather is going, I may not be getting at it until August. I was thinking to keep the cooler below the rad to let the rad work better for the engine coolant without the extra hot air through it. Any information or advice would be appreciated.

Thanks.

03-15-2019, 08:34 PM	#886
Northern 52 Registered User Join Date: Sep 2017 Location: Sudbury, Ontario Posts: 42	Re: S10 Swap how to I'm slowly plugging away on my 52 on an S10 frame. I am plumbing my transmission and decided to pick up an 8 x 14 cooler for it. It looks like it would fit nicely below the rad on the risers for the rad. I did the cross-member under the frame and sloped risers for the rad. Not knowing what the finished clearance would be but I am wondering if there will be enough air flow with the cooler in that location. From the pictures, the lower baffle below the rad to the grill looks like it might be at the half way point on the risers. My baffle is snowed into my shed and the way our weather is going, I may not be getting at it until August. I was thinking to keep the cooler below the rad to let the rad work better for the engine coolant without the extra hot air through it. Any information or advice would be appreciated. Thanks.