Re: Quality of Aftermarket Interior Door Parts: Handles, Switches, etc etc
I got my dome lights, door-pull pockets, door trim, & window + lock switches from LMC.
The trim didn't match factory stuff. I had NOS rear door interior trim & the LMC stuff for the front had a silver perimeter vs. chrome. I tweaked things so it didn't matter for my scheme.
The pass side door lock switch failed (plastic broke apart) on it's first actual use after initial install. I just mated the 'new' cover to the OG switch base.
The drivers side window switch had the plastic bezel clips break out w/limited use. The part was in place for several years but it's not exactly a daily driven truck. It was replaced w/a Dorman part.
The door pull pockets seemed fine & are stiff good. I didn't have to replace any of my actual handle assemblies.
Dome light bezels/bulb covers were fine.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|