The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

dec010974 · 02-18-2021, 09:50 AM

A lot has happened since I posted on this thread. Things happen behind the before one of the trucks can built, LSx swap, again. I ordered a high hump cover and installed just to yes fit. I ordered a power booster hydraulic clutch kit from CaptainFab, a board member. The LY6/TR6060 fully assembled and ready to drop in the truck. I also installed the hydraulic lines and bleeder clutch kit from Tick performance. Only thing left to do is figure out which route I can take for the wire harness to power the engine. The setup is 58x relucter wheel, with DBW. I need a throttle body and possibly a door pedal. I wish I could go DBC. But something will give. Her are some pics.

02-18-2021, 09:50 AM	#3
dec010974 Registered User Join Date: Oct 2012 Location: Miami, Florida Posts: 912	Re: LY6/TR6060 Swap from a 5.3/4L60E A lot has happened since I posted on this thread. Things happen behind the before one of the trucks can built, LSx swap, again. I ordered a high hump cover and installed just to yes fit. I ordered a power booster hydraulic clutch kit from CaptainFab, a board member. The LY6/TR6060 fully assembled and ready to drop in the truck. I also installed the hydraulic lines and bleeder clutch kit from Tick performance. Only thing left to do is figure out which route I can take for the wire harness to power the engine. The setup is 58x relucter wheel, with DBW. I need a throttle body and possibly a door pedal. I wish I could go DBC. But something will give. Her are some pics.