|
Re: carb question Bay city Mono-jet
Digging this one back up, I just put a larger air filter on my monojet, and I had to make longer threaded rod to install the big filter. The hole was stripped out on my bracket and I just put a nut on the bottom and one on top and used the pressure to tighten it together for now, but the problem is the nut keeps the throttle plate from going 100% open. It closes all the way with the choke but opens 80% only. I plan on taking it back apart to fix it correctly but my question is this;
If I weld a nut to the bottom of the bracket, wont this problem keep occuring?
Maybe a nut with smaller width, etc? not sure yet, truck is driveable but obviously not perfect with the throttle plate not WOT. Thanks
|