The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

otterby · 01-11-2021, 11:51 PM

So this thing is really throwing me for a loop. Replaced the motor mounts and transmission mount and there was no improvement. The frame is good around the steering box. The front end is square. Measuring off the bumper it actually could move a little in the opposite direction I need to get it away from the fan, so that’s not it. There isn’t any adjustment with the shroud. When I measure across the shroud opening to the center of the water pump shaft it’s an 1/2 inch off. So either the radiator support needs to move 1/2” to the drivers side or the motor needs to move 1/2” to the passenger side. What am I missing?

01-11-2021, 11:51 PM	#9
otterby Registered User Join Date: Aug 2011 Location: Casper, WY Posts: 20	Re: Fan Hitting Shroud So this thing is really throwing me for a loop. Replaced the motor mounts and transmission mount and there was no improvement. The frame is good around the steering box. The front end is square. Measuring off the bumper it actually could move a little in the opposite direction I need to get it away from the fan, so that’s not it. There isn’t any adjustment with the shroud. When I measure across the shroud opening to the center of the water pump shaft it’s an 1/2 inch off. So either the radiator support needs to move 1/2” to the drivers side or the motor needs to move 1/2” to the passenger side. What am I missing?