|
Issue #2
The box plates are designed to fit with the factory xmember in place and ive removed mine. this in itself isnt the issue and I assume that the cutout on the front edge of the boxplates is to allow it to slip over the normal x-member would this be right? (pic below)
Also the instructions say to place boxplate inside the upper and lower frame rails, which mine simply won’t do.
The rear end is simply too wide and angles off where the chassis is straight (pic below) and the front end appears to be right where the chassis rail narrows as it goes forwards (pic below).
Does anyone have any pics of the plates once installed or during install so that I can pass to my fabricator and we can make mods as needed to get it to fit.
I assume that the new xmember passes up into the chassis rails and that the box plates should be the same width as the verticals on the subframe to allow for welding later ......
Cheers Q
|