Re: C H E V R O L E T hood letter template needed
Actually it is steel sheet metal.
I had first planned aluminum and a lot more detail .
Yes the right side is the set up.
This locates the Most important/ R that is in the middle.
The Twist drills required are #24 (0.152) & #29 (0.136)
The right has scribe mark for alignment.
The left needed trimming for the (relief) to match.
That is just the Ruff phase.
I got 1 more Trick I hope to get this tweeked this week.
Number 24 drill for big holes on left
and number 29 for locating holes on the right.
Last edited by Getter-Done; 12-02-2018 at 11:55 PM.
|