The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**j_cst_10** · 11-16-2015, 12:09 PM

Diesel Wrencher - I went through some of your build thread, looks good. How well did the trans fit with the factory high hump floor? On my C10 it had a low hump and I ended up cutting a good chunk out.

My truck is 2wd so I've got to deal with the crossmember and I've got the engine as low and far back as possible. I am wondering how it will work out with my C20 with the high hump floor. I am running a getrag 5spd in mine so the dimensions our different but just curious.

11-16-2015, 12:09 PM	#6
j_cst_10 Senior Member Join Date: Nov 2008 Location: Cleveland, OH Posts: 575	Re: cummins C10 Diesel Wrencher - I went through some of your build thread, looks good. How well did the trans fit with the factory high hump floor? On my C10 it had a low hump and I ended up cutting a good chunk out. My truck is 2wd so I've got to deal with the crossmember and I've got the engine as low and far back as possible. I am wondering how it will work out with my C20 with the high hump floor. I am running a getrag 5spd in mine so the dimensions our different but just curious.