I just about figured out how and where to mount my accuair elevel sensors. Next is the shock relocators front and rear. I swear I saw a thread on this before but can’t find it now.
It looks like, with the front bags fully aired out, the shock bracket welded to the lower control arms will interfere with the tab that secures the brake lines. Is there a work around to this without a bunch more fabricating and welding? An extension bolt, and piggy back bracket or somehthing? My control arms are all painted up and finished so it would be a shame to have to start grinding and welding on them again.
I can get a lowered pic tomorrow if needed but in the pic you can see the two pieces almost make contact they are so close.
