Well this weekend started out with a disappointment. We had our hopes set on getting the motor ready to go in. I ordered an AC-Delco transmission filter/gasket and had a corvette shift solenoid for the 4l60E thats goin. Everything was good until we pulled the pan. There was a Ton of what looked like clutch material in the pan. I knew this was a possibility considering I got the motor from the junkyard but i was optimistic. So now we either have to try our hand at rebuilding it or have it done. We've never done one before so any tips are appreciated.
This is after we wiped most the junk out. the whole pan was covered
holding up the whole project now
