The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**cwcarpenter98** · 05-25-2019, 11:34 PM

Yesterday evening my mom and I went up to Blue Ridge, GA, for the cruise in at the Dairy Queen. Frankentruck ran great, and there were some great trucks to see. The only issue was sitting in traffic with no AC

On the way home, I realized that I had not shut the valve for the heater core off

so that made it a little warmer than it should have been... I turned it off today

The red truck is a factory 65 k10 with the original frame and transfer case. Has an ls and 4l60e now and a disc brake front axle. Really nice truck

The GMC panel is a NAPCO truck I think, but not sure. It did have a PTO driven winch

The white one is a Cameo pickup. Really nice restomod with a big block

05-25-2019, 11:34 PM	#306
cwcarpenter98 Senior Member Join Date: Jan 2018 Location: Hickory Flat, GA Posts: 4,421	Re: Frankentruck Yesterday evening my mom and I went up to Blue Ridge, GA, for the cruise in at the Dairy Queen. Frankentruck ran great, and there were some great trucks to see. The only issue was sitting in traffic with no AC On the way home, I realized that I had not shut the valve for the heater core off so that made it a little warmer than it should have been... I turned it off today The red truck is a factory 65 k10 with the original frame and transfer case. Has an ls and 4l60e now and a disc brake front axle. Really nice truck The GMC panel is a NAPCO truck I think, but not sure. It did have a PTO driven winch The white one is a Cameo pickup. Really nice restomod with a big block Attached Images __________________ Christian Carpenter 1963 C10 - Frankentruck 283, 3 speed with overdrive Overdrive wiring here 1963-ish truck bed trailer - Half-Wit 1981 C10 - Penny 305, th350 1995 Dodge Dakota Sport "I'll put it simple: if you're going hard enough left, you'll find yourself turning right." - Doc Hudson