Quote:
Originally Posted by Rusti
The original system is not perfect but it works. You have to bolt the plate where the cables are connected, shown in your picture, to the frame. Than just use an old brake cable and connect the little metal ball at the end to the original cable connector you show in picture number 3. The other end has to be connected to the park brake motor the same way you are showing in picture number 1 and 2.
Arnd
|
Not quite following ...... i've tried every combo I canthnk of ...... but it never puts tension on the passenger side.
Was thinking about seperating the cables ...... and joining like this and welding the two together.
Then the one main cable would pull both.
I would lose a bit of adjustment on each cable but I could use a pulley style to lengthen or loosen the wire as required.
thoughts ?