[N2TRUX]

I started with the installation at the rear of the truck by jacking it up and securing it on jack stands. Once the wheels were pulled I looked at the options for locating the ride height sensors. There were plenty of obstacles in the area that seemed best suited for mounting, but I was able to find a spot in front of the Ride Tech bolt in C notch.

Be sure to check for access to the area from all sides of where you plan to bolt the sensor in. Verify that there are no fuel or brake lines routed in the area before you start drilling holes. I had to reposition some line clamps to prevent any potential clearance concerns

The manual suggest using self taping screws, but I opted to use bolts with locking nuts to eliminate any sharp points that might protrude through the frame.