The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Headers on my 64 C-10

urmyboyblue · 03-17-2016, 05:20 PM

I did not have to cut my engine mounts at all. With the first set, I cut around 3/8-1/2" off the top flange of the driver side frame rail only- just to clear the tube off of #1. The second set required more of the flange to be cut out.

If you are ambitious, you could build a set. I built mine to route outside the frame rails on each side. The muffler sits under the cab and the exhaust exits in front of the rear wheel. I like this routing better than any other I have had.

03-17-2016, 05:20 PM	#11
urmyboyblue Registered User Join Date: Feb 2015 Location: Montevallo, AL Posts: 272	Re: Headers on my 64 C-10 I did not have to cut my engine mounts at all. With the first set, I cut around 3/8-1/2" off the top flange of the driver side frame rail only- just to clear the tube off of #1. The second set required more of the flange to be cut out. If you are ambitious, you could build a set. I built mine to route outside the frame rails on each side. The muffler sits under the cab and the exhaust exits in front of the rear wheel. I like this routing better than any other I have had.