The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project~”

Grizz1963 · 11-22-2018, 05:25 PM

Well.....

What does $80.00 buy you??

Dinner at Harry J’s.

Half a trolley of burgers n fries at Walmart.

Or 36 gallons of Fossil fuel for the Blazer in St Louis, Missouri this week.

Or if you are Dennis Jones in St Louis, then postage to the U.K. for some shackles for the Blazer.

Unpacked and a quick Catscan......

Approved.

Also included were some Disabled plates for my collection from Dennis and some of @CraigRK ‘s Coke purchases that were delivered after we departed the USA in September.

So what have we got for the Blazer this week?

Just a trim, bit off the sides and then a two inch drop in the rear.

Lovely pieces of kit.

Grinder and wrenches at the ready.

Hard to see on some pics, but here the same rake on both pics, and pic no 1shows the real state of the nation.

So trust me, the 2 inches will be just right, thanks to @PaulY

More when the sparks have flown.

Roll on weekend.

11-22-2018, 05:25 PM	#92
Grizz1963 Registered User Join Date: Dec 2012 Location: Rochester, KENT Posts: 10,480	Re: GRIZZ’s ‘79 - 2WD BLAZER Challenge over in London, England. “~It’s not a Project Well..... What does $80.00 buy you?? Dinner at Harry J’s. Half a trolley of burgers n fries at Walmart. Or 36 gallons of Fossil fuel for the Blazer in St Louis, Missouri this week. Or if you are Dennis Jones in St Louis, then postage to the U.K. for some shackles for the Blazer. Unpacked and a quick Catscan...... Approved. Also included were some Disabled plates for my collection from Dennis and some of @CraigRK ‘s Coke purchases that were delivered after we departed the USA in September. So what have we got for the Blazer this week? Just a trim, bit off the sides and then a two inch drop in the rear. Lovely pieces of kit. Grinder and wrenches at the ready. Hard to see on some pics, but here the same rake on both pics, and pic no 1shows the real state of the nation. So trust me, the 2 inches will be just right, thanks to @PaulY More when the sparks have flown. Roll on weekend. __________________ MY BUILD LINK: http://67-72chevytrucks.com/vboard/s...585901]Redneck Express - 1966 C10 Short Fleetside MY USA ROADTRIPS http://forum.retro-rides.org/thread/...2018-humdinger IF YOU CAN'T FIX IT WITH A HAMMER, YOU'VE GOT AN ELECTRICAL PROBLEM MATE.