[67C10Step]

Driveline is all back in and full of gear oil. Ignition switch does not work in the START position so I have a push button wired in under the hood. Pulled the plugs and turned the engine over with the starter a few times to make sure all was well. Plugs show the engine to be running rich so I’ll clean them up and put them back in.
The under hood wiring is a mess so I am going to temp in power to the coil and ignition box tomorrow. Have disconnected the fuel tank from the pump so my plan is to bottle feed it and get it running. After that I’ll run through the entire fuel system.
So much to work out but one thing at a time.