The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Asshat · 10-30-2020, 09:17 PM

Does this bearing look right? Pretty sure it goes this way.

And, it looks like you have to install the fork and yoke before the transmission is moved into place. Does that make sense? Or can you install the bearing on the trans shaft, slide the transmission into place and then slide the yoke lever into the bearing?

10-30-2020, 09:17 PM	#44
Asshat Registered User Join Date: Jul 2015 Location: South Orange County CA Posts: 1,259	Re: Pulling motor question Does this bearing look right? Pretty sure it goes this way. And, it looks like you have to install the fork and yoke before the transmission is moved into place. Does that make sense? Or can you install the bearing on the trans shaft, slide the transmission into place and then slide the yoke lever into the bearing? Attached Images __________________ 1963 C20, small window, long bed 292, 4-speed Last edited by Asshat; 10-30-2020 at 10:07 PM.