Re: Pulling motor question
Quote:
Originally Posted by Desert dog
Sorry no pictures. But I'm pretty sure it was the 1.85" one though. Also in regards to the clutch fork, I typically install the bearing on the installed fork first and then install the input shaft through the bearing.
A couple of things to note. The clutch fork should have a clip in place that snaps over the ball stud in the bell housing. Don't forget a dab of grease there. A lot of them are missing. And the throw out bearing needs to be installed on the forks correctly. The forks go behind the metal tabs. I hope this helps.
|
I do have the clip in place. And good on the grease.
What do you mean the forks go behind the metal tabs? You mean in the slot of the bearing?
__________________
1963 C20, small window, long bed
292, 4-speed
|