|
Re: Family Project 65 C10 SWB "Old Blue"
More baby steps! I stripped the wiring harness again, since my first try didn't give me enough slack. The harness I have is from a Silverado, which mounts the computer and fuses on the fender under the hood and the wiring harness comes from the drivers side inner fender over the top of the intake and then down to the connections. I want the computer under the dash with the wiring harness entering behind the engine and spreading out from there. I had to extend a few power wires, one ground wire, the alternator and temperature sensor.
I also wired up the fuse and relay block. I now have 12v Battery, Keyed 12v, Ground, and fuel pump feed to connect. i also wired up the OBD2 connector and have it ready to go.
Now to put the sheath back on the wires and get everything taped up.
|