Ok, so I know this is probably no big deal to most, but I am real excited...
I HAVE POWER IN THE GARRAGE FOR THE WELDER!!!!!!
That's right, one year after buying my welder I hooked it up! I can't believe this year has been so busy! I actually went to look at my burb the first time with the welder in the back of the Yukon!
I grabbed a few pieces of scrap to run a few beads on to test it out. I was too excited to clean off the work, so...
I have a side project that is paying for the Yukon engine going on right now. This is a Dana 60 semi floater housing from an International truck. I am building it with 3.73, POWR-LOK limited slip and 35 spline axles. The axle shafts will be drilled for 5x5 studs and it will be set up for disc brakes. The WMS spread on this axle will be 62 3/8" without the discs installed. As you guessed, it is going under a 70 Chevy pick-up so it will get chevy trailing arm mounts. The truck is using a full length trac bar. Thought you guys would like to see it!
Also, I pushed the third seat for the burb all the way back and its become my chill out spot...
