[youngrodder]

Originally Posted by Advanced Design

....yeah but it doesn't have the aluminum fender option.



The shop is 60' x 100' and the front half is the shop. Built by my Dad and uncle in the late 1960's out of 3 and 4 inch drill stem pipe. Been there before on kick panels and floor pieces. The little black truck spoiled me as it was rock solid.



Thanks Jim, always appreciate your words of encouragement.



Great Marc that looks good, I am taking the same route. GM didn't spare on the spot welds when they installed the seat riser. Now to figure out why it is still attached at the back.

Having a great time.....now to figure out how to do this full time.

I learned that the seat riser will not come out without taking the wood out. The back is also spot welded. What I did was used a jig saw and cut the rear tab that runs the lenght of the riser off. Once I remove my wood I will reatach the back tab to the riser.

Good luck
Marc