The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**clay68c10** · 06-15-2019, 10:08 AM

The bed sides are really beat, I think they'll just warp if I weld on them. Lots of old bondo over dents and rust.
Oh well, the bed floor is decent thru the middle section.
So I cut off the ends and make a new edge for the rear.
I practiced on the piece I cut off, then worked the floor.

06-15-2019, 10:08 AM	#11
clay68c10 Senior Member Join Date: Aug 2004 Location: Centennial, CO Posts: 2,895	Re: ClusterTruck; because that’s what it is The bed sides are really beat, I think they'll just warp if I weld on them. Lots of old bondo over dents and rust. Oh well, the bed floor is decent thru the middle section. So I cut off the ends and make a new edge for the rear. I practiced on the piece I cut off, then worked the floor. Attached Images __________________ ClusterTruck: 68 C10 Bought in 89, wrecked in 03. Slow low $ rebuild started '17. 6.0 & TKO http://67-72chevytrucks.com/vboard/s...d.php?t=788602 93 K1500 Short Step, 350, NV4500, EBL flash ECU. Vortec heads & roller cam someday... 05 Jeep Wrangler Unlimited. 3” lift & 6-speed 02 E320 the insurance total “free car” 13 Tahoe LTZ Last edited by clay68c10; 06-15-2019 at 10:17 AM.