alright, bit of a update...
lets cut to the chase. first off i wanna say this is my first c10 build ever. i don't have any experience bagging trucks or even doing a frame off build. I'm enjoying it though for sure. after cutting/drilling/air chisel all the stock x members are gone. my PB stuff is here and I'm prepping for mock up. i have already installed the dropmember rack notches and started putting the tubular cross members in.
also i deleted the factory frame curve for the fuel pump (i believe) thats what it was for, and made it flush. i later did more work on it and made it symmetrical to the other side . with a little radius to a point. I'm planning on boxing the frame upfront, and in back in a section. also recently i picked up a 6.0l truck motor and it is mated to a 6l80e. came with all the wiring, dbw, dash, seats, pile of parts.
i also started shaving my firewall and installed the porter built hood hinges.
more to come
