The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 1-Piece Window and a better bodyline....??? (pic)

**raggedjim** · 12-05-2006, 11:45 AM

It is supported vertically by the felt channels that run from the bottoms of the door to the top of the door in the rear and the top of the vent window channel in the front. Once you get so high you have the vent window channel and just a small amount of door channel in the rear holding it. If you take away the vent window there would be little support at all.

There's probably a way it can be done, but i'm not smart enuff to figure it out (as you can tell by the pics I have posted, I've been thinking about this for a while...)

Good luck, Rg

12-05-2006, 11:45 AM	#20
raggedjim Senior Member Join Date: Jun 2002 Location: Murray, Kentucky Posts: 3,377	Re: 1-Piece Window and a better bodyline....??? (pic) It is supported vertically by the felt channels that run from the bottoms of the door to the top of the door in the rear and the top of the vent window channel in the front. Once you get so high you have the vent window channel and just a small amount of door channel in the rear holding it. If you take away the vent window there would be little support at all. There's probably a way it can be done, but i'm not smart enuff to figure it out (as you can tell by the pics I have posted, I've been thinking about this for a while...) Good luck, Rg __________________ Roger '68 Short step - https://67-72chevytrucks.com/vboard/...d.php?t=849675 '69 ('70?) 2wd Blazer '70 GMC Jimmy 2wd Last edited by raggedjim; 12-05-2006 at 11:45 AM. Reason: I type like a third grader...