The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

72TXSuperCheyenne · 05-14-2010, 10:03 AM

Well, not all today, but over the past week or so with a little (well a lot) of help.

Installed EPWI 1.6/1.5 roller rockers.
Installed Edelbrock aluminum valve covers.
Ran, cut, constructed boots, and installed MSD Street zero resistance plug wires.
New belts and hoses all around.
New SFI 29.1 fly wheel.
Installed N&N Air Filter.

Tomorrow - installing 700R4, level 3 transmission.
installing switch on factory A/C so compressor does not run all the time.

coming up next few weekends:
New cab mounts.
Front suspension rebuild, ball joints, bushings, tie rods,
1" spacer between carb and intake manifold
run new fuel line from fuel pump to carb

05-14-2010, 10:03 AM	#120
72TXSuperCheyenne Registered User Join Date: Apr 2010 Location: Fort Worth, TX Posts: 48	Re: What did you do to your truck today! Well, not all today, but over the past week or so with a little (well a lot) of help. Installed EPWI 1.6/1.5 roller rockers. Installed Edelbrock aluminum valve covers. Ran, cut, constructed boots, and installed MSD Street zero resistance plug wires. New belts and hoses all around. New SFI 29.1 fly wheel. Installed N&N Air Filter. Tomorrow - installing 700R4, level 3 transmission. installing switch on factory A/C so compressor does not run all the time. coming up next few weekends: New cab mounts. Front suspension rebuild, ball joints, bushings, tie rods, 1" spacer between carb and intake manifold run new fuel line from fuel pump to carb Attached Images Last edited by 72TXSuperCheyenne; 05-14-2010 at 01:53 PM.