Quote:
Originally Posted by Mack B
That 2" block will push the rear forward some due to the angle of the arms where the axle sits, I'm not sure how drastic that will be. Note that with 15" wheels the arms will be below scrub line in the event of a flat tire with those blocks.
I'd measure wheel base center to center and see how close it is to the 115" stock wheelbase. I can't tell from the pictures but I would think the bed is slid a bit to far forward, there is a sizable gap between the two on stepsides. The architecture of the fleet side hides that gap and makes it appear tighter.
|
That was my next thing measure wheelbase see where we’re at. I know the front wheels were always centered centered from the factory, that’s why many use aftermarket to move them forward an inch. But the bet sat right back into its original mounting holes. All 6 bolts lined up nicely.