[SCOTI]

Originally Posted by SCOTI

I highly recommend 'over-doing' the c-notch if planning to tow. A simple bolt-in raised floor allows for better frame rail height above the notch & ample pumpkin clearance (win/win). It doesn't have to steal too-much interior compartment space. Even raised just 2" allows for a superior ('safer' since you're a family guy) set-up & wouldn't be that noticeable.

Originally Posted by BlueJeep

Thanks! The whole family is on board with it, as soon as I get a few things fixed (including A/C).

Thanks for the heads-up, and I'm already on it! I already measured the space between the top of the diff and the floor, and used that as my measurement as to how deep the notch reasonably should be. I want to cut as little as necessary because hooking up a trailer is still important to me.

Here's an image of a shop built notch. Not much clearance gained for the work but it is what it is. I bet if you extended the plating on both sides of the frame to where it's just below the floor (box the inside of the rail & plate the outside portion), you gain strength & could go ~3" into the rail. wouldn't have to cap the top off making it an easier install (as long as it doesn't trap moisture).