Thread: TA_C10: Stage 1
View Single Post
Old 12-02-2020, 12:09 AM   #1025
SkidmoreGarage
Registered User
 
Join Date: Mar 2020
Location: Portland, OR
Posts: 335
Re: TA_C10: Stage 1

That sounds like a plan. If you can get a steel fitting, you could tack it in place to prevent it from backing out.

Regarding the cutting of the thread, I wouldn't recommend it due to the taper cut of the threads. If you don't over drive the trap into the hole, and don't thread the elbow in to far, you should be set.
SkidmoreGarage is offline   Reply With Quote