|
Re: Project: LS1ick68
Ok, is there anything right in front of the tank? I see a cross member for mounting your bed wood to. If there is enough space directly below that member can you weld a plate in there? I would make the mount from angle iron just big enough to mount both filter and pump on and then weld it on but leave holes in it to get to your bed wood bolts.
Then again was your tank ever setup for an in-tank pump?
I have an older Holley pump that has a return right on the pump so its a straight shot right to the top of my tank. It was rated at 160gph for street use and I used the mallory filter I listed. I usually go for overkill in my vehicles so no matter how much power I want everything will be ready for that next upgrade. Since were on the fuel subject, are you going to use existing hardlines or go all AN?
|