The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

88notchback · 08-05-2019, 06:59 AM

Madkidd007, Good point. I'm wanting to basically do it all with the truck. I'm not stuck in any certain typical hobby, but want it to handle alot better than it does as well as hook better too. The 50year old suspension wasn't designed for any of that.

I'm currently looking into going with a chopping block frame on air, but not the slammed version. Setting the truck up with this wont be that more exspensive than if I was piecing the IFS and rear section up to handle the power with frame stiffner and most important the stopping power. Alot of details to work out but being new to most this, but I'm learning alot from the site.

08-05-2019, 06:59 AM	#10
88notchback Registered User Join Date: Jun 2018 Location: College Station Posts: 51	Re: ZR1 LS9 swap Madkidd007, Good point. I'm wanting to basically do it all with the truck. I'm not stuck in any certain typical hobby, but want it to handle alot better than it does as well as hook better too. The 50year old suspension wasn't designed for any of that. I'm currently looking into going with a chopping block frame on air, but not the slammed version. Setting the truck up with this wont be that more exspensive than if I was piecing the IFS and rear section up to handle the power with frame stiffner and most important the stopping power. Alot of details to work out but being new to most this, but I'm learning alot from the site.