I finally made a tiny bit of progress. Nothing has been easy so far. I purchased the entire brake system and the booster and master cylinder should be here tomorrow or Thursday.
The bolts holding the rear wheel cylinder on are, pretty much, not coming out. I'm going to take a grinder to them in the next few days. The brake hoses that NAPA gave me were the wrong hoses so I have to take them back tomorrow.
After all of that, I managed to get 1 front rotor, caliper, wheel bearing, seals and set of pads on today. I could have gotten the other side done but I spent about 45 minutes cleaning the spindle. It took a scraper and lots of scrubbing.
Here's the picture of my tiny bit of progress.
