[chevyguy_72]

And now my question to you guys... When i originally started this project i wanted the boards to run wheel well to wheel well... But that just not possible with my tire size... at least the rear... so trying to decide if i should match the front up with the wheel well (assuming i dont have any clearance issues when turning) and trim the back as needed or equal space front and back depending on the how much trimming is needed in the rear?
Pics are where it needs to be in the back for now... i have a slightly bigger tire in mind so might have to be trimmed a little more and the outside of the tape mark on the front would be where the end of the plastic cap would need to be to match the back...